 |
Permanent Magnet Motors - PM MotorsDC Brush Motors feature low noise and high efficiencyHansen Pemanent Magnet DC Brush Motors have unique performance advantages that make them the best choice for simple, high efficiency DC drives and servo motors. Hansen Permanent Magnet DC Brush Motors feature die cast endbells and ball bearings for long life and optimized heat transfer. Custom windings can be tailored to your specific needs and Encoders and electrical noise suppression can be added, if required. NMB-MAT DC Permanent Magnet Motors feature lifetime lubricated sintered bronze bearings and built-in electrical noise suppression. However, it is the low audible noise on the majority of NMB-MAT’s motor line that really sets them apart from other Asian manufacturers. The new SE series motors use a four pole design with rare earth magnets to achieve the highest output power per cubic inch available in any mass produced motor. Hansen’s line of DC Brush gear motors features an SE15 DC Permanent Magnet Motor mounted on Hansen's Synchron gear train. These DC Brush motors are available in five mounting configurations and a wide range of gear ratios. This high-efficiency, low-cost DC brush motor design features permanently lubricated sintered bearings and long life brush. Also in Hansen's line is the Hansen Size 16 Motor on a 2” diameter gearbox with ball bearing on the motor, sintered bronze bearings on the output shaft, and heat-treated sintered steel gears.
|
